Microphone Windscreens

Microphone Windscreens

What is Dynamic Microphones

Dynamic microphones work via electromagnetic induction. They are robust, relatively inexpensive and resistant to moisture, and for this reason they are widely used on-stage by singers. Moving coil microphones use the same dynamic principle as in a loudspeaker, only reversed. A small movable induction coil, positioned in the magnetic field of a permanent magnet, is attached to the diaphragm. When sound enters through the windscreen of the microphone, the sound wave moves the diaphragm. When the diaphragm vibrates, the coil moves in the magnetic field, producing a varying current in the coil through electromagnetic induction. A single dynamic membrane will not respond linearly to all audio frequencies. Some microphones for this reason utilize multiple membranes for the different parts of the audio spectrum and then combine the resulting signals. Combining the multiple signals correctly is difficult and designs that do this are rare and tend to be expensive. There are on the other hand several designs that are more specifically aimed towards isolated parts of the audio spectrum. The AKG D 112, for example, is designed for bass response rather than treble[2]. In audio engineering several kinds of microphones are often used at the same time to get the best result.

Ribbon microphones use a thin, usually corrugated metal ribbon suspended in a magnetic field. The ribbon is electrically connected to the microphone's output, and its vibration within the magnetic field generates the electrical signal. Ribbon microphones are similar to moving coil microphones in the sense that both produce sound by means of magnetic induction. Basic ribbon microphones detect sound in a bidirectional (also called figure-eight) pattern because the ribbon, which is open to sound both front and back, responds to the pressure gradient rather than the sound pressure. Though the symmetrical front and rear pickup can be a nuisance in normal stereo recording, the high side rejection can be used to advantage by positioning a Ribbon Microphone horizontally, for example above cymbals, so that the rear lobe picks up only sound from the cymbals. Crossed figure 8, or Blumlein stereo recording is gaining in popularity, and the figure 8 response of a ribbon microphone is ideal for that application.

Other directional patterns are produced by enclosing one side of the ribbon in an acoustic trap or baffle, allowing sound to reach only one side. Older ribbon microphones, some of which still give very High Quality sound reproduction, were once valued for this reason, but a good low-frequency response could only be obtained if the ribbon is suspended very loosely, and this made them fragile. Modern ribbon materials, including new nanomaterials[3] have now been introduced that eliminate those concerns, and even improve the effective dynamic range of ribbon microphones at low frequencies. Protective wind screens can reduce the danger of damaging a vintage ribbon, and also reduce plosive artifacts in the recording. Properly designed wind screens produce negligible treble attenuation. In common with other classes of Dynamic Microphone, ribbon microphones don't require phantom power; in fact, this voltage can damage some older ribbon microphones. (There are some new modern ribbon microphone designs which incorporate a preamplifier and therefore do require phantom power, also there are new ribbon materials available that are immune to wind blasts and phantom power.)

About the Author

I am a author from www.cheaponsale.com

where can i buy a Microphone Windscreen?

I don't really know what it's called its like this big black cottonish ball that goes on top of a microphone to sing. Where can i buy it in staten island?

You can buy a microphone Windscreen from http://www.amazon.com/gp/search?ie=UTF8&keywords=microphone%20Windscreen&tag=new-deals-20&index=mi&linkCode=ur2&camp=1789&creative=9325

DIY fake fur microphone windscreen